Recent content by getonwithit

Does anyone know where I can purchase angled connector blocks so that I can form a good tight joint on my 72.5 degree plinth situated below my base units.

I did not say that I was using an electrician that did'nt known something! I am just checking!!

Does anyone have the sky code for a LOGIK L22DVD B10 so that I am able to control the TV with my sky remote control. I have been in touch with Sky but the codes they supplied do not work.

I am in England. What tests need carried out and in what sequence? I assume that when you say energised you mean turn the power on to the new circuit / cables? I thought I would get good advice from this website hence the basic questions. All I am trying to do is check that my job is...

I am not the person doing the work, but the person watching. I was wanting second opinions on here.

I am chasing my kitchen walls for my new cables. When I get to the worktop level is it acceptable to leave the cable out of the wall (behind base unit) and maybe enclose them in surface mounted conduit

Is there a correct way to position the twin and earth cable when using a junction box with three connectors ie does the earth have to be in the middle or not

How many sockets can you have on a ring main?

Is 2.5 ok as this is what I have used

What size cable after the fused connection unit. I have 2.5mm in, can I hve same size out or does it need to be 1.5mm

Can I use 20 amp junction box at the end of my fused connection spur to connect the flex of my lights

OOps, Just realised what your answer meant. I leave the 15 A fuse as it is. Thanks.

Fuse was a 15 A and an old type. Identified with blue circles and uses fuse wire. Can I mark up the front so that any future electrician knows or do I need to get a new fuse wire holder?

Does anyone know if it is possible to utilise an extint emersion heater cable and use it for lighting to the underside of my new kitchen cupboards. At present the fuse has been removed from the CU. Is it a case of down rating the fuse to 5 amp? Or do I start from scratch?

Can anyone help me solve the problem with extractor noise causing distress to my next door neighbour. The problem is my in-line fan being secured to the roof truss (screwed) with the hum noise being picked up next door at night. I have turned down the over run but I really need to secure the fan...