Recent content by ginger100

yep,cheers colin for your help, the wife was doin my head in, now shes as snug as a bug :D

hi colin, out of frustration I decided to replace the main pcb, now the boiler works as it should, with no issues with the hot water or the ch system, so do you think my problem was the pcb and nothing else, cheers jd.

ok colin will have a go at that, thanks for the reply,cheers jd.

a poor lowly bricklayer

thankyou mr gasright, most helpful, its so refreshing to know there are people out there willing to help a fellow tradesman with anothers expertise,cheers jd

hi, I am having problems with my boiler, the glowworm 30 cxi its approx 7 years old we had a power cut as a result by boiler packed up, initially showing a f13 code, after leaving it shut down for a day or two i restarted it and it started up ok so then I went and turned the hot tap on and the...

thanks for that is there anyway of testing the PCB or is it a replacment job, I did check the fuse and it looked to be in good order, if its a new PCB have you any idea how much a replacement one would cost,cheers jd.

hi all I have had a glow worm 30 cxi combi boiler installed, maintained, and trouble free for 7 years, recently we had a power cut and when the power came on again the boiler was showwing a F12 fault ,telling me to check the wiring, before I had chance to do anything we had another power cut...

hi, i have a ribon wire connection that has worn strips at the end and will only work when i jiggle it about and i am prety sure the conductive paint has worn nealy all away, so my question is has anyone used such a repair in the past and how did you get on with it, do you think it is a viable...

yes i happen to have some tucked away somewhere, cheers,jd.

hi, I have to repair a screed floor after a suspected water leak, there is no longer a leak problem, all the old felt lagging has been removed to expose about an 18 inch run of copper pipe, I want to seal the screedand sub floor with a cwment based waterproof slurry, then make good the floor, my...

hi, i am having trouble with a cubase 5 program, my sound card is giving me a audio in latancy of 350 m/sec my system is using direct x c-media, wondered if there is any way of reducing the latancy problem to 10-40 m/secs,cheers jd.

hi all, I've got a hilti te 104 with a needle gun chuck but I want the breaker chuck, can anyone help,cheers jd.

the vent was put there for a reason, trust what you have and the reasons for it.

I can only surgest looking for a fire surround to sute the job there are plenty out there to sute your taste and will give you something to plaster to as well perhaps, sorry if this answer doesn't inspire you I did my fireplace out a bit back and grabbed a bargain surround and mantle for...