Hi all,
I'm having some issues with replacing our old Honeywell T6160B1004 room thermostat which has just packed in after being a bit intermittent.
I have an old ideal Mexico system boiler
Initially I purchased a 2 wire digital thermostat and attempted to make it work but for some reason it...
I'm looking for a reasonably decent detection tool to enable me to drill into walls without worrying about hitting anything I shouldn't
Ideally I need it to work with Brick walls and plaster walls if possible (cavity wall house)
I've had a look at the ones sold in the likes of B&Q etc such as...
That helps a lot thankyou all very much! I'll give it another try with the jumper in the gravity position and hopefully that's all that's needed for now.
Apologies yes that is the case (hot water pressure at the taps is abysmal)
The drayton programmer has a jumper on the back for pumped and gravity now that I'm looking at it. Is it simply a case of moving that over to gravity but keeping the wiring the same?
Thanks!
Ok I had tried that but found I could only get the boiler to turn on when I switched on the DHW side. I'll give it another try and see if I've missed something.
Thanks!
I am having some issues swapping from an old 24 hour mechanical programmer to a new 7 day programmer.
The old programmer is a siemens RWB2E
and the new programmer is a Drayton LP722
The issue I have is with the wiring. (we have just had a full re-wire done and apparently none of the central...