Recent content by graemep123

  1. G

    weedkiller on bulbs?

    Can i spray weedkiller over an area thats now overgrown without killing the daffodil bulbs that are underneath? They are obviously hibernating now but are due to grow soon. Thanks
  2. G

    using a floor sander on decking

    Cheers but ive alredy tried that and its gone a bit in places but not in others. Just thought the sander might take a layer of grime off the top face at the edges and along the smaller faces of the grooves?
  3. G

    using a floor sander on decking

    Is it feasible to use one of the large floor sanders on outdoor decking. Ours has been washed and cleaned but still has staining. I was wondering if it would be ok to give it a light sanding before applying the decking oil? Thanks
  4. G

    Damp ceiling

    Hello My en suite shower has been leaking and a stain has appeared on the living room ceiling, underneath the leak. Will this need to be replaced or is it ok just to re paint it as I think ive now sealed the shower and fixed the leak. The ceiling isnt bowed or anything just a brownish stain...
  5. G

    Decking questions

    Ive read about Cuprinol anti slip decking treatment and was wondering if this is the best stuff to use on a shaded decked area which is prone to falling leaves etc. Also on a separate note, when would you be required to obtain planning permission before decking a garden? Thanks in advance
  6. G

    i need a screw!!

    brilliant! thanks
  7. G

    i need a screw!!

    Now ive got your attention, i need some screws to fix my door handles on. The ones im looking for come in 2 parts, one end like a normal screw and the other half is like the female equivalent which has a screw head on but the male screw joins through the door and tightens into the female side...
  8. G

    AEG Double Oven

    Just moved house and the AEG double oven trips the main circuit breaker for the house when i switch on the top oven/grill. This doesnt happen when the bottom/main oven is used. Any ideas how a complete novice should fix this or should i just pay up and get someone in to look at it? Thanks
Back
Top