I have a Duravit Stark 1 close coupled toilet which has begun to flush poorly. The cistern functions fine, but there seems to be a partial blockage just where the water enters the toilet pan which results in the main stream at the back of the pan being reduced. I have investigated and there...
Many thanks to all who have posted to date and special thanks to "lostinthelight" for his link to schematics - very useful for the inexperienced dismantler! I shall let you know how things progress..
Looks like I cannot access the igniter unit to disconnect any wires without removing the grey plastic housing on my FS38. Is there a specific way to do this as there appear to be several screws on the housing which may or may not be holding it in place and I don't want to remove any more screws...
Got spark plug tested as you suggested and it seems there is no spark visible. Have tried several ways to arrange this including testing with a conductivity meter to ensure electrical contact and there is definitely no spark.
I have a Stihl FS38 petrol strimmer which was working well until I tried running it at less than full throttle for a few minutes. The engine stalled out and all efforts to restart it have failed.
I tried following manufacturers recommendations for starting a possibly flooded engine without...
Many thanks to all who responded.
I have since been able to access the hinge screws and make adjustments to these hinges. While carrying out adjustments it became clear that the main issue here is actually stiffness of the hinge itself to any movement! I have tried lubricating the hinge a couple...
Thank you, that's very helpful. The door has been working just fine for about 8 years so I'll assume it was originally fitted correctly. Can you advise how to access the hinge adjustment as it looks to be covered by a chrome plate.
Good afternoon, the door on my Matki LCQ Illusion Quintesse shower enclosure keeps springing open. Can anyone provide information on how to adjust this type of door so that it stays shut when taking a sower? I have been unable to find detailed information on how to achieve this.
Ideas gratefully...
I am having a heck of a time trying to get the plastic control knob off an older-style Danfoss thermostatic radiator valve in order to gain access to the stuck valve pin. It does not seem to unscrew and there is no (obvious) mechanism to allow removal. I'm sure there is an easy trick to do this...