Recent content by hooly

quite a few, bit wider then hairline, cant afford full skim thin scrim and easi fill or toupret, though i read its hard work to use, so many diff products,? or what ever u thinks best cheers [/img]

If felt, it should have green drips around the edge asphelt is laid in one go, Mastic asphalt is a mixture of limestone and bitumen and is commonly used to provide waterproof and hardwearing surface to roofs, balconies, roof top car parks and service decks . The bitumen and closely graded...

That is wooden deck and felted, i think you mixing up asphelt, and felting? I would avoid epdm, its sold by companies with there own installers, as for 30 yr guarantee, will the firm be around then? Stick to tried and tested felt, Most roofs join to next doors and have awkward shapes...

One i did, but i no experience, best not to try £500 cost to pour n roll, mats only, using trad felts, last 15yrs prob [/img] I would ask and check, to see felts, as some tell you anything, ie 3 layers and do 1, or dont take the old stuff off, just go over

In my area it would be £22 per metre, to felt 3 layers hot bitumen, green min edges, using trad felts, not poly felts, poly ht felts cost more, so check!! asphelt would normally be on a concrete roof, not wooden deck! If he can do it now, i would wonder why? most good ones would be busy...

I want to do a garage with one of the above, wondering if anyone as any good prastice ideas, and rough cost of metarials? also edge trims for the cold seal method, that go over the felt on the sides, never seen them about? cheers

How thick can you plaster in one coat? How long to dry before tiling? Would pollyfilla be better use?

Tiles are off, were the bath sits it needs plastering were loose, does the plaster need to rest on the bath, or do i try to keep a few mill off? before i tile. Is one coat plaster the one i need for filling a few gaps? REGARDS

Best best to start again kill the grass off, rotavate, rake level then re-seed or turf. you could hire a turf stripper then replace it but without knowing the size its hard to say it it would be worth it. you`ll never do it by a roller alone.