Cheers @flameport
So I'm going to stick with 65 on the tank and I will put the boiler at 70....? That sound OK?
I missread the hive instructions and went down the set up for gravity/part pumped systems... I saw the part pumped bit and went with that.... now I read it again I see it stated...
All done... found the hive set up at toolstation, fetched it and after a bit of messing around with the buttons have it all progrmmed up...
I have it set in 'gravity fed mode which I think is correct....
While I have you @stem , I know this has probably been asked and answered a million times...
I was hoping to get you @stem . Thanks for the reply.
Just to clarify.... Room thermostat cable? I have a wireless thermostat that talks to the WR1 (I believe).... The WR1 is currently removed with a link between terminal 1 and 3 to bypass its function for now.
Below is the photo of the WR1...
I have done a bit of searching online and find a lot of hits here but nothing that is specific to me so I have signed up for some expert help.
I have a convensional boiler with Birtish Gas UP2 programmer and WR1 reciever with thermostat. My WR1 has failed (did have it repaired by a guy on ebay...
So I am planning to pay a builder to take out a structural wall (ground floor supporting floor above)...
I have a had a builder come in and quote up for the work... When I mentioned building regs to him he asked how long we were planning on staying in the house... I told him we will be here for...