Recent content by IloveDIYNot

Hello noesall, OK, I think I understand where your coming from. If I was therefor to start again, I would use brink , say for 1M and then introduce 4x2 timbers at about 400mm to a 4x4 plat on the top and then place the roof on this, but with that said , can you confirm where I can find out...

have a long garage at present that I wish to convert in to a car port and work shop. Its built of timber and covered on the outside with T&G wood. It looks as though its a converted hut or something as inside the original owner added some extra support to the pitched roof which is covered...

Hi mrrigidtool, I too have all the qualifications in electronics but when it comes to something like this , get the big boys in if your not sure. Instead of being chocked on fumes you may be running for your life. But with that said, check out TLC's web site for cable size calculations...

At present its 6550 long X 4700 wide. I plan to incraese the length to 9600 and use the back 4100 as a work shop. Between the garage and the workshop I will build a stud wall. At present the wooden garage sits on a 1M deep single brick foundation which sticks out the ground by 2 bricks...

Nothing at all, its just extra cost ....

I have a large garage at present that I wish to convert in to a car port and work shop. Its built of timber and covered on the outside with T&G wood. It looks as though its a converted hut or something as inside the original owner added some extra support to the pitched roof which is covered...