Thanks, sorry I meant the installation manual and programming manual.
When going into ‘change inputs’ and creating a new one, I’ve set the type to ‘Tamper’. But I have no way of relating this to Z1?
Thanks, i only have Z1 and Z2 on my board.
Z1 will be fine right?
Also could you give me a brief description on how to program a tamper for the bell. Looking in the user guide but can’t pinpoint section I’m after
In the engineers mode, I have gone to ‘CHANGE OUTPUTS’ and within that section I can see that ‘BELL’ is set to ‘SIREN ANY’ .
What other programming would be needed for the bell to work?
Thanks in advance
could it also be continuously sounding (even when I put it in engineer mode) because in the 0v trigger that I’ve connected the bell to, I also have the tamper going in there too.
I haven’t done any output programmings. I’m quite new to this alarm installations. Will this cause the alarm to sound without going off on initial power up?
Thanks All,
I have added a 2k2 resistor to the bell in panel and connected it to the 0v In the panel and it’s now sounding. However, bloody thing wouldn’t go off. I had to disconnect the wiring to get it to shut up.
Hi all,
Can someone help me. I have installed a new Pyronix enforcer 32 and a delta bell siren. The existing wiring was already in the walls.
I’ve wired up as followed:
Backlight Disable >>>> not used
T >>>> Com on main panel
T >>>> 0v on bell with 2k2 resistor
Eng. Hold >>>> Not used
Bell...