Thanks again, the leak seems coming from a pipe joint. The location of the joint is, if you have the manual, page 6 figure 1.18 the joint is marked "J" in the picture. There was staining down the pipe with a collection of water on the self as the pipe passes down to the lower section of the...
Thanks for that, but can you tell me if I need to drain the boiler before disconnecting the diverter valve? I will be taking care of the leak, what is the best compound to seal the threads? I should have the new valve by Wednesday. I will give it a go then.
Regards
Eureka!! I think I have found the problem. When I took the cover plates off I saw some staining near the cable entry point inside the boiler. On further examination I followed the likely route and there was a lot of staining on the pipe up to the heat exchanger. There was a bit of a puddle on...
Thanks for that input, I hope to get a hold of a PAT on Monday. In the interim has anyone had a similar problem to mine and maybe shed a bit more light on the problem. I will take the covers off the system today and use the mark one eyeball to check out for leaks.
Thanks again, in anticipation.
A bit of further information. On further checking there doesn't appear to be an earth fault on the fan or the pump. Tonight I replaced the fuses and switched off the CH and powered up the boiler. I drew hot water from the kitchen sink on and off for about 45 mins and the system worked fine. I...
Hi thanks for taking up the challeng. I have metered the fan and get a reading of approx. 30 ohms. The pump has a capacitor across it as I am sure you know and I get a low initial reading but it settles on about 215 ohms. Does this provide any clues? I'm not sure what the norm is for these...
Hi Folks,
I have a couple of questions that you might be able to help me with. Firstly, can someone help with a manual for the Ariston Micro Genus 27 MFFI. I have tried the MTS web site and they pointed me at www.centralheating.co.uk. When I tried there the files I downloaded were corrupt. I...