Recent content by jambono5

thanks

cheers, tey do just thing. do u know where distribute these? worth tryin parts centre or pts?

pretty sure the potentiometers have no stops on these boards (can turn 360 degrees) , just on the knobs. the knob may be set wrong in the pot, did this once the other way round so that if u turned it past half it overheated! just a case of removin the board turnin the knob back and puttin it back

hard 2 say without being in front of it, would have thought pcb unless the aps is stuck in the n/o position. easily tested tho

Pretty sure that was the preupgrade model so agree that that would b the 1st thing i would check, also if it has been doing it 4 a while the felt seal round the burner can be blown out, may also need replacing

any1 any idea where you can buy a decent pressure gauge 2 b used when fittin a remote filling loop to a system with a combi fitted in a loft? thanks

know its took a while to reply but have changed the 1amp fuse, put in the code and am back up and running! cheers europlex turned what i thought was gonna be an expensive job into a relitively cheap 1!

thanks spark, better make a shopping list for maplins by the sound of it!

thanks for the reply, will fetch some fuses in the morning and hope for the best! don't know if it will make any difference but the alarm has been switched off for about 3 weeks, will this affect the battery? thanks

hi, Came home the other day to find that my loving dog had decided to rip up my carpets and chew through 2 cables to the alarm! The alarm is a eurosec cp7 or 8 not sure how to distinguish? i have cut back the cables and reconnected them, i'm sure i have wired them correctly as one of the...