Recent content by Jamie211

Hi experts I have a premier elite 48 metal with a 8xp Is it possible to use the programable outputs to open/close a motorised garage door opener via the texecom app or do I need the additional relay output board? Thanks

Thanks Sparkymarka, I thought having resistors was the recommended way, using less cores and to monitor line shorts & opens?

Good evening, Could I please have some help wiring a Texecom Impaq Plus with Contact, Ideally I'd like to wire the reed and vibration to two separate zones on the 48 to aid fault finding, in the unit I have; | Alarm | Alarm | Tamp | Tamp | Latch | Reed | Reed | I know I have to use resistors...

have a look at the ComWifi module, you will see that the chip manufacturer is USR, if I recall correctly, its not something you'll get from Texecom

Look up the chip manufacturers manual, this will give you a diagram of the pin numbers, you then short the reset pin to ground pin, be careful not to short the wrong pins, this will reset to factory defaults.

Thanks Secreiam, Sorted!

Hi secureiam, Could you advise how to do that please Thanks

Hi, This is my first post on this site My query relates to a Texecom Comwifi module, on the initial module setup to retrieve its MAC address, I appear to have made an error whilst changing the password & username , maybe due to a typo and now can't access its settings again. Is there away to...