So I have now primed the pump and still no hot shower. But I noticed the flow on the hot side was very poor.
I checked the incoming hot and the pressure is fine. So something must be blocking the pump.
I took the pump out and decided to blow into the tubes. On the cold side the air...
I made a minor alteration on the incoming hot and cold feeds, as the tails were too short to reach the new pump location. I extend the tails by 3 inches.
I'll prime the pump properly as you have suggested. Thanks.
I have recently replaced a Monsoon 25T pump for a second hand ShowerMate 1.4 Twin.
I was expecting it to be a quick like for like replacement, but it appears the hot water is being overridden by the cold. I primed the pump by running the shower with no power to the pump for a period of time...
The full power down did the trick.
1) Mains power switched off first
2) Opened panel, disconnected battery, external alarm sounded.
3) Reconnect battery, external alarm stopped, closed panel
4) Mains power restored
Keypad was then functioning showing DAY and ZONE A leds.
My original...
Thanks all, I only have one RKP on the system. Dip switch set to 1.
I will try a full power down first, then an NVM reset.
When I fully power down the system, do I have to wait for any amount of time before bringing back to power up ?
Thanks for the reply.
I will try the NVM reset as I have the manual.
I have two questions
1) Is there anyway of stopping the external sounder, as when I initially powered down the system and disconnected the battery when I first fitted the new 9827 keypad the outside alarm went off. So...
Hi all,
Having read on these forums, I purchased 2 scantronic 9827 keypads to replace the 9800 keypad.
At the weekend I took the plunge and replaced my old 9800 keypad. I powered down the system at the mains (battery was left connected) and connected the 9827 panel. It was all very simple...