just looked this morning at the actuator and it defo unscrews from
valve unit plus,i have had the whole thing off to replace the syncron
motor so think it has already been adapted....
cheers again dia...
guys thanks for your help on my little situ
have sourced said powerhead will attempt
this first to see if it cures my woe's
http://www.uk-plumbing.com/honeywell-40003916001-replacement-powerhead-for-v4043h-p-41209.html
not a bad price i thought
again mandate and doitall both thanks...
its honeywell and seems to have 59421 stamped on the top of it
if that helps looks like it has 5 wires blue,grey,red,white...and a
green and yellow wire
can't find the serial tag inside the cover and should the motor
be hot with heating on.....
i've just looked at a couple and they look exactly the same aaaaarrrrrgggg don't know with out stripping the cupboard out
whats the difference if you don't mind me asking???
cheers
so do i get a new actuator then.do you know if this comes with a motor in it
or am i being thick and have to get a new motor aswell...
cheers....
all i can say is i was told it is a y plan separate circuit for hot water
and central heating...its got a 1 in 2 out with a rubber ball valve under the
actuator..
The actuator is what you call the powerhead
cheers...
hey matt
no it did work fine up till last year then allsorts started happening
kept thinking i was burning the motors out.so nice to know i'm not going
mental...
have not messed with the wiring so not sure
all i did do was install a syncron motor twice and i'm right in
thinking that...
hi there guys.....
i'm new to this site....so hi there...
right my problem is as follows 4 months ago i replaced for the second time the syncron motor in the diverter valve on my y plan system... from what i understand the motor flips the micro switch for hot water and for heating on the...