Recent content by jim87

Took this photo when fixing mine, maybe it helps ? Jim

turned out to be the PCB that was at fault. Got a replacement, and now it works again :D cheers

ha ha, yeah that's how I felt after trying to fix mine the other day :) Already had to fix this one 5 or 6 times since I got it ! Oh by the way, I just remembered that I said move the pump in a left to right direction, but that's not correct, it was a right to left direction .. oops

Sure, from what I can remember, i did the following: 1. Unplug machine :) 2. Take the plastic panel on the back and the bottom of the machine, where the drain pipe comes out. Two screws hold it on I think. 3. Looking inside, on the right hand side of the machine, at the bottom is the...

Cheers for the advice rocks :) , that sounds like my best option

Hi rocks Waste is the same place its been for the last 5 years - the waste pipe u bend is about 2-3 feet off the ground, and then it goes into the kitchen sink u bend. I was begining to think there's something up with the PCB, but wanted to check and see if I missed anything else before...

Hi all, My washer dryer has come up with this error code, Reduce Creases - LED 2 flashing. It does this about 1 - 2 minutes into the cycle. I've been trying to work out whats causing it. From this site, i've found out that this means 'Pressure sensor stuck on empty', so I've tried the...