Recent content by jorgemandrade

Oh really? Wonder why it says on the instructions to use self adhesive underlay when floating?

When using underlay for floating, does it need to be self adhesive for this flooring?

Hello everybody, just looking for some advice please. I have got this flooring from homebase: https://www.homebase.co.uk/15mm-solid-parawood-flooring/12816499.html I need to fit it in a bedroom upstairs that has got timber floor planks. Reading at the instructions it says that I can: 1. glue...

Yes I can run heating without hot water if need to but I'm concerned it might damage the pump as the system is pretty much drained. Could I refill the system using the vent pipe?

Yes the tee is out of reach. I have attached a picture of what I believe my system is which now makes me think. If that is correct, the only way to drain the Expansion tank is through the boiler because the pump is not running and the motorised valve is shut as I switched off the heating...

I have attached a picture. The 15mm feed pipe and 22mm vent pipe from F&E cistern can be seen side by side between heating controls and Radiators wireless thermostat receiver shown on top right corner of the picture. I was thinking to run it only for a short period, maybe just hot water to the...

That tee is most likely in the ceiling void or in chimney breast where the boiler is which I won't be able to access. The 15mm pipe from F&E cistern comes down through airing cupboard so that tee must be somewhere on ground floor. Is there any way to try to unblock it? Could I try to run the...

I have this laminate already for a few years actually, so I will have to use it.

I haven't decided yet but was looking to something like gold foil 5mm. Not sure if it will be too soft for the laminate. Any recommendations please. Ideally I would like an underlay 7 or 8mm thick so the flooring would be level with the adjacent rooms which have got tiles.

Hello, I have got 6mm laminate for a concrete floor and was considering putting a 5 or 6mm underlay. Will that be a problem? Thx

I have got a typical gravity fed heating system with cold water and small header tanks in the loft, hot water cylinder, heating control, pump and 2-way valve in airing cupboard and back boiler and fire on chimney breast downstairs. Today I drained the central heating system by removing a...

Hello, I have got this Bristan Mixer and I need to get a new cartridge, any advice where I can get a compatible one from, thx.

Well, flex goes around cylinder and is only about 1 metre long before joining a 15mm copper tube that goes to the power shower. Wide angle shot? What does that exactly mean?

Dunno, always been like that since I moved in 2 years ago. Can you see something not quite right?