You was bang on the money secureiam.
I was on a texecom site but not the same as the one you linked to.
Downloaded the latest version and she connected right up.
So I need to solder this on to my panel? Is there no way to use it without soldering it on?
Or can I unplug the smart comm and use com2 then replug back in after I'm done?
You mean the one top middle where you put the red ribbon cable on the left with the 1.
I did that also and got same error.
I also get same error with SmartComm which works fine on the app?
One was already set I suspect for my SmartComm module for setting and unsetting the alarm.
I also try connect via that but it says the same error.
I plug the cable into the engineering keypad plug on the left hand side of the board.
Ah so I am not sure about that. Where do I set that in both panel and Wintex?
I set the UDL password on wintex to same as panel if that's what you mean
Hello
I am connecting with Wintex for the first time and not sure why it will not connect
I created a new site and added the upt password in the site details.
When I connect using PC-Com it just says reading panel type and serial number then after a few moments an error saying it can not...