Thanks DP, thing is, if it’s a choice between wrecking a pump (with a stupid design flaw) or spending a lifetime waving magnets near it I think I’ll take my chances !
Livng in a bungalow theres little head of water to the kitchen sink, so purchased a Salamander pump to boost the hot water to tap. Worked perfectly for 6 months but now the only way to get it to kick in is to wave a strong permanent magnet on the end of a wand near the end of the unit.
Now, what...
There must be hundreds of miles of domestic buried in plastered walls at all kind of angles. We never used to consider "zones" years ago, and the sky didn't fall in. Having said that in future before drilling a wall have a cable detector run a pass.
I would like some advice on insulating my kitchen floor please. I have ceramic tiles laid on a sound and dry 50mm screed, but during the winter the room is always cold. I'm quite prepared to lift the screed to accommodate an insulation material, but there are pipes crossing the floor buried in...
It sounds a bit like Wickes. Often it's difficult to find decent timber because the lengths have been picked over and over until only the crap stuff is left on display. Some should never have been put out there, but some mug will always buy it.
Hi, I want to stop my bathroom door opening on its own accord. I thought there was a problem with the door frame being out of plumb, but cannot find evidence of this being the case. Of course if closed all the way it latches and stays there but it always swings back towards the wall if not. I...
Getting fed up with replacing batteries in my kitchen clock. Does anyone know of any device or kit to get it to run off the mains ? The battery is AA 1.5 volt. I have lots of ex phone chargers but would need to know how to bring the volts down.
What is the correct way to install an outside rcd socket ?
1). Connect to ring main, but when test button is pressed it takes out whole of the house because both main and socket are 30ma rated.
2) Replace main RCD in consumer unit with a higher rated tripping current.
3) Use an...
Why are there no reducing couplings on the market to accommodate the old sized round 65mm to 68mm downpipe. And vice-versa ?
Plenty of square -round jobbies but surely you don't have to replace every fitting. We're talking plastic here guys.
Hi guys
I plan to render a piece of frost damaged outside wall. What mix would be best and what materials ?
Do I make good the flaked off fronts of some of the damaged bricks with ordinary sand & cement first ?
Thanks
Kbultray