nope, its free standing.
i've used a normal hand saw before, just thought this might be easier.
I dont have loads of tools so just but do have a jig saw.
By looking at another response it would seem to not be the tool of choice.
I'll just get my hand saw out and use that i think.
Cheers
I have a new fence post i need to install.
its 100mmX100mmX2140mm
i need to cut some V shapes out of it to hold the horizontal supports.
i have a Jigsaw from an old project and thinking i can use that instead of making a wonky mess of a hand saw.
Looking online i get the impression the 10CM...
I wonder if someone can help me.
I have an issue with my boiler where with the C boiler status and the burner light flashing and then igniting.
The problem since is that the burner stays on only for about a minute or less and the burner light continuously flashes all the time, after a while...
I need to replace my Sentinel Combiguard cartridge but ive not done it before.
it obviously connected to the central heating system but i'm warried that during the phyiscal replacement at somepoint i need to unscrew it; wont water just start pooring out of the pipe work until i screw the...
I have a zanussi double oven which every 6 months or so keeps blowing the element. All of a sudden the trip switch goes and the over will then not be able to heat the over. I buy a new element and all is ok for 6 months. When i look at the element it appears that the rings have fused...
Hi all,
I have recently bought a second hand Program 2000 fully integrated dishwasher. I got the old door off but looking at the parts i can see how to put the door for our kitchen on. i have added two link below which are the parts used to fit it but if anyone knows or perhaps can point me...
Boilerman2 you're a genius. I've installed a £12 thermostat and now the radiators stay on and get hot until the hall reaches the temp desired. For 3 years now the heating would click on and off again before any of the rads got hot.
D_Hailsham you're too a genius. The wiring notes worked a...
Hi there, i have a Sunvic TLX 9201 fitted by the builders when i bought my house 3 years ago. Its always been a pain. I have a digital temperature gauge and when i place it on the thermostat i notice that if i set the thermo to 21 degrees it would switch off when the hall was only 16 degrees...