Recent content by KevC1

Any reason why cable for heating controls can't be run in the same hole as heating pipe? The electrician has threaded his cable through the same drilled hole which I've put my plastic heating pipe through. Not sure if this is ok. Should I get him to re run it in it's own hole? Cheers.

Thanks for reply. I've put it in the CC. Not sure I can give you many more clues. I'm fairly new to fault finding, so I usually need all the help I can get. Thanks.

Hello, Been to look at a Glow worm ultimate 50 ff. Boiler is making a loud buzzing noise, and neons 1 and 3 are lit. I was thinking it might be the air pressure switch, but i'm not that familiar with these boilers. Anybody have any ideas. Thanks.

Do you have manufacturers instructions? Most boilers require 300mm not 600.

Ring vokera and they will tell you. I've done one, and it's not quite the same as removing the link. You have to swap a couple of wires, but I can't remember which. Vokera are happy to tell you though.

ha ha ha ha....never heard such a stupid idea in my life!!!!!

Is there a reason honeywell 2 port valves have a 6 core wire on the 28mm, and a 5 core on the 22mm. The reason I ask is that I was converting a gravity system to a c-plan. I put a normal 22mm 2 port on it. When I came to wire it, it needed white core to turn boiler on for heating. Had to buy...

It needs to have a fire resistant barrier between the boiler compartment and the space used for storage. You also need a notice clearly displayed in the boiler compartment stating that it shoudn't be used for storage. I know this because I had a defect notice from gas safe stating it on an...

Hi, Fitted a Potterton Gold in the last couple of days. Customer called me last night to say there was an error code...E133. I checked inlet pressure, and when it was firing it was only 7MB. I happened to have a meter regulator in my van so swapped the existing one, and all was fine...

Turn your boiler up so the temp is 75. It will be in condensing mode for longer and be more efficient. The heating shouldn't cost any more than before. Incidentally, why didn't you go for stored water if you're having more than one bathroom?

Good luck! You really need to find the external stop tap to be able to replace your stop tap. You could try freezing it if you can access it. If access is awkward you could get a push fit stop tap wich might make life easier.

There is a sensor in the top of the condensate trap which is probably wet from the trap being full. This needs drying, otherwise it's still telling the PCB that the trap is full.

oh yeah, I could even pick up the neutral and earth for the pump in the wiring centre.

I think i've got it! I can use the neutral and earth from the boiler for the pump.

I guess it's not ideal to have the boiler booting up from nothing every time there's a call for heat. I have done two this way with no problems. I think I can manage to get the pump lead from the boiler back to the pump, then I can use one of the other cores as a switched live. Thanks for...