Recent content by KIMMO

Ok will do. Final question where would be the best place then to take off the hot. I assume somewhere along the pipe that runs up out of the top of the HW cylinder and vents into the cold tank ?

OK thanks. I wondered about raising the cold storage tank a little. I wont acheive much but I guess I could get 50 cm? The shower valve is rated down to 0.1 bar but I guess that is borderline. http://www.victoriaplumb.com/Scene_Concealed___Thermostatic_Twin_Shower_Valve.html this feeds an 8"...

Softus. distance from base of cold tank to shower head is approx 1.5M. The shower is upstairs in a house and the hot water cylider is mounted on the same floor some 4 metres away. Since it is mounted on the floorboards it lies below the shower valve and head. Could this be a problem. I'm getting...

I have replaced an existing basic 'Mira' mixer shower with a temperature regulated twin tap valve. Possibl related I also fitted a new basin. The shower is fed from the existing 15mm pipes that fed the old shower. Having fitted it I turned on the tap and nothing happened. Neither hot nor cold...