Recent content by Kingbee

Went round Andy's place friday afternoon and the problem seemed fairly clear from ground level. The wonderful expensive aerial engineer had not replaced the connection box lid on the aerial! After a quick look and one corroded aerial replaced, and downlead while I was at it, the picture was...

Thank you gentlemen for your time. The booster was bypassed when the picture started to break up after a few times to eliminate it from the arguement. Sadly it proved nothing as the picture neither deteriated or improved. It would seem Andy claims that it doesn't have to rain for it to...

Hello everyone, A friend of mine keeps asking me for a solution to his tv picture troubles and I'm stumped also. Here we go. It would seem he has a super aerial (aerial engineer's description) and new signal booster box(fitted by above) and a reasonably new tv with freeview intergrated. The tv...

Hello rocks1, Had to leave it in bits over weekend but it has just been put together and followed your instructions. The element did have voltage across it for a few moments at start of cycle but at 15 mins there was no hissing and no voltage. The element still checks out 30 ohms. If the...

Hello rocks1, no error lights but F13 only showed up once in 3 identical dryer faults so I sadly have little faith in them. As for heating up the water, even with an insulated door you can still feel warmth especially on 95 cottons program. Cold drum on opening and some clothes not washed also.

Hello, Could anyone suggest why the above mc wont heat the cold water. I have tested the heating element ( 30 Ohms) so assume its ok. Physically it looks fine as well. There is a probe (temp. sensor?) in the same rubber seal which reads open circuit so could this be the bit which is...

Ok. Thank you for your help, Craig. Thought that might be a solution but was trying to aviod the draining down bit!

Hello out there :D I seem to have a problem with the seperation of hot water and radiator circuits. It is a recent issue as the system has worked fine for nearly 20 years. When the time switch (danfoss 4033) asks for hot water only the only rad upstairs gets hot, but the rads downstairs...