Recent content by kingfisher1548

Morning all. Just wondering how much I should be expecting to pay to have a new boiler fitted. I have everything there in the airing cupboard including hot water cylinder and f/e tanks in attic. This would be remove the old and replace with new. Just a rough price please to install as I...

Hi, Looking at replacing my old boiler. Currently have a myson apollo fanfare with hot water tank in airing cupboard and 2 small tanks in attic. I have a family of 4 living in a 3 bedroom terraced house with 7 rads and 1 bathroom with a Trevi boost shower. Would I be better off with a combi or...

Do you think it may be the pump worn out and not pushing?

Hi, thanks for your response. Yes the pump keeps running when H/W is selected, it always has done.

Myson apollo fanfare boiler. Help needed please. Turn on C/H and can hear motorised valve move, pump starts spinning and then very short fire up from boiler. After that initial fire up it won't fire up again. Turn on H/W, pump starts spinning but just won't fire up. Pilot light is on and no...

Anyone have any ideas please to point me in the right direction?

Hi all, I'm looking for advice on an old myson apollo fanfare boiler. Turn on either the hot water or central heating and it fires up no problem for several minutes and then stops. Fires up again for a few seconds then stops. Won't fire up again until I switch off and wait for the fan to stop...

Hi, Anyone offer any help on this. I've just removed the old tiled floor in the kitchen and it looks like the old tiles had been stuck down with some sort of bitumin type glue. I have solid concrete floors and I'm left with a sticky/tacky black mess. It's not very thick, just a very light...

Hi all, Has anyone used this flooring? What's it like, any good or a waste of money. It's not cheap at over £10/msq. Basically, it's a floating vinyl floor (not glued to floor) that's fixed together with a glued tongue and groove sort of fitting. laminate floor but in vinyl!! I'm looking...

So I guess it should'nt be this hot then? Why is it not overflowing?

Hi, Should the vent pipe that comes off the top of my hot water cylinder that bends into the tank in the attic be getting hot (to hot to touch)?? If not, what would usually be the cause of this getting hot?? No water seems to spill out from the overflow into the garden. I have condensation...

Yea, looks good. Grey wire connected to yellow from cyl stat and yellow HW off from programmer. Does this mean something is faulty?

Still not clear what I need to do to remedy this. Does this mean I'm possibly wired wrongly or is something at fault?

excuse my ignorance seco, what do I need to do to sort this please.

Hello again seco, thought I had all this sorted. Thanks for your help last time. Could you please explain more about the grey wire, where should this go? I haven't got it in the wrong hole again have I?