Recent content by lee1234b

i agree with you mate all new systems should be flushed too get the crap out the system but i dont think this is the problem , i think its down to the pipework or perhaps something too do with the auto byepass valve, its only a 5 rad system so it should be blasting around the rads ...........

no it didnt have a power flush , but to be honest i dont think this would be the problem because there should not be a lot off debris in the system being all new........

hello, i have trouble with one radiator in the house, ever since the plumbers fitted a new boiler and radiators and new pipework the lounge radiator never gets hot all over , it gets hot at the top but the middle to bottom gets loop warm cold, tryed balancing the rads but no joy , switched all...

thanks for your help mate , am going to change the diverter valve body tomz see if that does it..........

am sure, i have the manual in hand it says e 13 water deficiency error - appliance blocked,maximum permissable temperture rise of ntc1 has been exceeded appliance blocked for 10 minutes.......

ok i will try unplugging the wire too flow switch and fire it up in central heating mode, if the boiler stays on in central heating mode would this mean its the flow switch..... if the flow switch is ok could it be the diverter valve body getting stuck. some times the code e 13 appears when...

no, the boiler doesnt fire up on its own unless the central heating is in demand , the hot water side is fine no problems.....

thanks for the reply, sorry i forgot too mention that i have changed the actuator diverter valve and it still does the same, when the boiler is switched on in central heating mode you can see the valve move it to central heating mode but after a minute or so it moves back up and the boiler cuts...

Hi, i have a vaillant ecomx 824e the trouble is 6 days ago the central heating as stoped working , but the hot water is working fine the flow pipe off the central heating is getting hot for about 2 metres and the rad above the boiler is getting loop warm if that. some times and not always a code...