Recent content by Lee4all

Is it safe though , i often worry that these additives would upset the wheel balance. I don't allways drive as carefull(slow) as i should. :wink:

Has anyone heared of / used this green slime called e tech tyre sealant? I have a link http://www.thegreenreaper.co.uk/showdetails.asp?id=1308 I have leaking rims on my Volvo V70 and i am tempted to use it. Any comments ?

Can anyone help ? :?

The wiring is as the honeywell diagram so yes the live supply is permanent. The boiler is fine all day then it goes off in the evening via the programmer but the next morning it will show error f23 push reset then it shows s97 then s98 then s53. Leave it switched off at the 3 amp switch for...

:) Can anyone help please?

Can anyone help with a wiring schematic that will work ?

Thanks for the help :) I have removed my wiring from 3 and 4 and replaced with a link. Hot water ok on demand. Wired in a Grasslin towerchron Qe1 to prove the heating all ok there as well , so it has to be my wiring of the mid position. I've followed the wiring scematics in the link in my...

Thanks for that i,ll give that a try, you thinking like me it could be the pcb !!!

Thanks for the input, i,m still at a loss though as what to do next. If i am to get this system up and running i need to prove either the wiring/valve is faulty or i could even have a boiler fault! :?

:? S Plan Suitable for fully pumped installations with two primary circuits, usually one for heating and one for domestic hot water. The DHW is not pumped on a 837! Y plan Similar to the W Plan but with the ability to supply both heating and hot water circuits at the same time, if...

Help peeps ! Customer has a vaillant 837 and decides they want a pumped shower for their main bathroom (5 bed, two bathrooms and an ensuite) I fit the cylinder, shower, pump etc etc and then wire in the mid position valve ,cylinder stat, room stat and two channel programmer. As in the linky...

The pump has surely been proven to work (it spins freely during hot water draw off) the more i think (its hurting,lol ) its looking like the Pcb.

Is this on the divertor valve ???

Anyone else feel free to help ...... Tia.