Recent content by liszega

Many thanks.

Please kindly correct me if I am missing something as I am only a DIY'er... If I could still make use of the control panel zone set as unused (instead of wiring in a small buzzer as per your suggestion) to know if a supervision signal has not been received from the bell or the battery is low...

Just had another look at the installation manual - would setting the zone as 'unused' help in this scenario?

Hello, I am trying to install a solar powered bell box (Lynteck LY52-050-43) to my Accenta G4 control panel. Everything is pretty much straightforward except one function. The bell box converter (the receiver you install next to the control panel) has (in addition to the standard terminals)...

Lynteck LY52-050-43

Gentleman, Apologies for late reply however I was busy between attending work and fitting the wardrobe. First of all thank you both again for your advice. I have used @JohnW2's method as you suggested its safer and everything works as intended. Great stuff. Everything works as intended, same...

Its the fan. So looking at the front of the switch from the left: Fuse | Fan | Light

Gentleman, Many thanks for your help. I will sort it tomorrow and feedback if any problems. Hope this post with the images attached will helps others. Again, thank you.

@JohnW2 I believe this is what you meant...:

@JohnW2 Can you please kindly confirm I understood you correctly?: @EFLImpudence By following your Diagram the switch I want remove will no longer have any connections as I am disconnecting all 6 wires going to it, correct? Many thanks.

@JohnW2 Please kindly advice.

@EFLImpudence: Did you mean when the switch gang for the fan is on? If so then yes. But as it is 2 gang you can have the fan on with no light and vice versa. But pressing the switch does switch it on and off. Hope this makes sense. I am happy to explain further is required. Yes it is clear...

Would these be any better? Two angles here. Or did you meant to disconnect them from switch?

This is a photo of the other switch, it us also fused to add to my confusion... Please advise if you need any better shots of this one.

Hello, Hopefully someone will be able to assist me. Please note I have read through other posts on the subject but I am still not 100% sure... I have a 2 way light switch system to my upstairs bathroom. One in the hallway and a second one in the master bedroom. This is because there is an...