We have a small plot of agricultural land (5 acres) currently used for a few sheep and an ancient horse.
We would love to build ourselves a house on it but on investigation have found that the only way we would get permission granted is if we were to prove that we need to be on site 24hrs to...
All sorted now.
I contacted the manufactures and was given the correct wiring procedure which is;
Plug in the boiler to an earthed socket, Remove the black link cable in positions 6-7, Connect common switch live from controller to position 1.
My electrician was amazed that it was that...
The boiler has definitely not been wired to the 24v side. This is the first boiler fit for a newly gas safe registered plumber.
Ok can we start again.
How would any of you who are far more experienced in fitting boilers go about wiring a Potterton controller to the Intergas Compact HRE 30 ov...
Hi Dan
The boiler is definitely heating the water and all electrical connections are in the 230v side, the two linked cables in the 24v side were factory fitted.
The boiler has been connected via the old controller because that is where the connections from the room stat, cylinder stat...
I'm not sure! the wiring on the previous boiler leaves quite a bit to desire. All the cable come from upstairs so the electrician use a bit of detection to at least get some power to the boiler. When the previous boiler was installed the electrician only put in a triple and earth when the boiler...
I have just had my boiler replaced. The old boiler was a Potterton Neataheat e60 the new one is a Intergas Compact HRE 30 OV boiler.
The old system was run by a potterton controller/programer up in the airing cupboard. The installer has managed to initialise the boiler but without the pump...