I can wire the sounder to the output but I have to wire the F terminal (strobe) to 12v (panel) on the control panel then wire the C terminal (sounder) to the 0v (panel) and make a link from the S terminal to the F terminal in the sounder, but I want the strobe and sounder to run independently
I'll look into getting one, I also want to say that I managed to wire a kinetic external sounder to the outputs and it worked good as gold, I'm really confident it is the sounder not being compatible
I've changed the output polarity from 0=POS to 1=NEG and wired the sounder to the panel as shown in the images, left the jumpers in and still getting the pop sound when the sounder is supposedly active, it also pops again when the sounder is off.
So after hours of faffing around with the sounder I managed to make a link to the sounder to make the flash and sounder work together but I still want to make the sounder and strobe run independently. Is it even possible?
Exact same problem I'm having right now, hope somebody can help us. :-(
What is your firmware? You can find that by entering your code, 23 ent. Mine is 3.51
Hi,
I'm attempting to write an internal sounder to a Honeywell Galaxy FX020 control panel and I want to wire the strobe and the sounder independently rather than make a link from the sounder terminal to the strobe terminal.
But it seems I can only wire one of the terminals and not both...
I'm still not sure what kind of relay I need, I got the internal sounder, the door contacts and the DC power supply, it's just a relay I'm having trouble finding.
Anyone got any suggestions?