Recent content by luke1612

thanks.......

can any one help by confirming the following for me.... i want to install a hand drier (3KW) and water heater (2.5KW) in a room with a toilet and sink. there ia an existing socket in the room, so i was wanting to replace the socket (which is part of a ring) with two switched fused spures one...

instead of patronizing people, why dont you do what is intended of this internet site and actually use your experience to help ( i say experience instead of knowledge because we all may be knowledable in some discipline, which you have no idea) which makes you a knob in my opinion..

nickso, havent you got anything else to do apart from sitting on your computer and making a knob of your self

nickso is on the wrong planet!!!!!!!!!!!!!!!!!!

ok thanks DP, so would you suggest a new HE and system flush. just as a matter of interest is there a method what could verify this theory before i went ahead and bought a new HE thanks luke

scatmanjohn- right, first i put the radiators on and altered the temp control- flame stayed the same. next, tried with rads off and hot water on- flame stayed the same But went out when got to the min range of the temp controller and back on when turned back up (but flames same size)...

he didnt say...copper it is then, ANY thoughts on the faults luke

yes, its the main one above the burner. when i took it in to be repaired the chaps first reaction was that it wasn't made of copper. but said that they would be able to sort it for me. they found two leaks on it and silver soldered them. Since fitting it i haven't lost any pressure so the actual...

the HE is not made from copper, and a full pressure test was done, but i suppose there will always be a risk. in this case the risk of another leak was weighed up against the cost of a new HE...... only time can tell we live and learn luke

had the leak silver soldered by a specialist, and after refitting there were no leaks luke

VOKERA MAXIN 24E background- my central heating for some time has not been maintaining the 1.5 bar pressure. i checked high and low and could not figure where the leak was coming from, and would top up pressure at least once a day. But the boiler itself worked fine. (this been going on for 3...