Recent content by luke3917

Did you have your 155 descaled Christian ? I got the same problem and I am interested in your results Thanks Luke3917

-------- Andytw. The hot water pump is boiling to touch and so are the pipes in and out of the hot water pump. I unscrew the knob in front of the hot water pump and hot water came up. I tightened right back. The side of the hot water pump has a metal case that came away as I touched it. It has...

Hello Iancmd, Thanks for the reply. I have a powermax 155. I am still looking for the best option to fix this moster. powerflush-descale, etc Thanks

Anyone with helpful suggestions

Hello. I have a power max 155 open vented system system. BG replaced the blending valve as I had tepid low flow hot water from taps and shower. The New valve made no difference to the temperature or the flow. BG says the coil in the tank is full of scale and the part is obsolete. I called Baxi...

Hello Croydoncorgi. HDI contact you - I have a power max 155 that had its blending valve replaced and I still have tepid - no pressure hot water. BG says coild scaled and I need a new boiler. I have read that the coil could be power flush or descale Luke3917

Hello a Jeffries. I have a powermax 155 and I need some advise after my blending valve ws replaced by BG and my CHW is still tepid to cold and with no pressure. BG is saying my coil is scaled

Well, it was the blending valve as initially suggested. I had boiler cover with British gas, but I was not sure if parts were covered. Gave them a call- all is covered was the answer. Engineer came, young chap. I discussed my observations and he politely listened. I left him alone after 20 mins...

I have read the initial thread post by Kevindgas. I think i know what steps to remove the blending valve on my powermax 155. I hope this is the luke warm water problem I have.

Hi, I have a powermax 155. The hot water runs hot for a short while when the tap is turned on the it gets luke warm. I have read in the forum in different threads that it might be the blending valve. I located a medium size 't' valve with a black top that has calcium deposits on it and at each...

Thanks for the tip Breezer, I had to tilt the machine to the side to avoid disconnecting the water hoses, that gave me access to the bottom of the washing machine where I loosened 3 screws holding the drain pump see...

Thanks for the tip breezer, will remove it and inspect it.

Hello, I need help with my Zanussi Jetsystem 1250 FJS 1397. It takes water in but, on all cycles, it tumbles slow, it never empties the water, it finishes the cycle leaving my clothes damp and the drum full of water. I ran a cycle with no water in the drum, and it tumbled fast and completed the...

struggling with my PowerMax 155 HW