I have lifted old linoleum that was glued down. In lifting the old linoleum some of the plywood has been damaged, some thin veneers have lifted leaving soon obvious indentations that require making good.
Is there a product that I can use to make good the plywood surface so that it will be...
Hi
I have an existing slate floor that looks good wet but not so when dry.
Is there a product out there that will give a permanent "wet look" finish.
The floor has already been sealed and is dirty so I would probably need to strip that off.
What product would I use for preping the...
I have a new Franke sink to install.
It came with 2 washers for the waste, one is rubber with ridges one side and flat the other. The other washer is a felt-like material.
I am guessing that the felt one goes under the waste on top of the sink and the rubber one goes under the sink with...
I have installed a Baumatic cooker hood in accordance with maufacturers instructions but when I switch on there is a crackling sound coming from the 3amp fused connector unit.
I also had a mains powered radio on in the next room at the time and the sound went right down when I switched the...
I need advice please. For some reason my kitchen floor is made up of half concrete screed and the other half is timber floor boards. The boards finish level with the top of the screed and there is vinyl over the top of the lot.
I am laying slate tiles so do I put down plywood over the whole...
I have got three fluorescent tube type under-cabinet lighting units that I want to wire to the main kitchen light switch so as I turn on the main light the cabinet lights come on as well. They daisy chain together and the last one has a wire coming out with exposed ends where it was previously...