namsag....
I could only find one kit and one diaphragm on its own. I think they'd be the same, the kit would probably include the spring and other pieces.
Mark
Thanks namsag. So if its a universal one I found this at Keeptheheaton.com.....
Worcester 8-716-140-553-0 Diaphram Replacement Kit
Diaphram Replacement Kit
I take it this should be it.
Mark
Yep I've already changed the diaphragm once before, but I can't remember the part number to get another one. It is a fiddle to get to and replace, but its pretty straight forward.
Any other suggestions regarding the part number.
Mark
Can anyone tell me the part number for a Diaphragm for a Worcester 24CDI boiler, and maybe the best place to order one.
Hope someone can help,
Thanks in advance,
Mark.
Can anyone tell me whether it would pay to go with an electric boiler for CH and hot water or to stick with my Gas LPG combi system. I haven't heard much about the electric boilers, but they do sound a good idea. Would they work out more expensive to run compared to gas. My electricity supplier...
OK this is my problem. Where the two flow and return 22mm pipes enter the boiler, they are connected to a compression fitting which has an on/off screw to them. After turning one of these screws to stop the flow, it now leaks. I need to know either the item number or what these are called so I...
Ok thanks for that. May seem a daft question, but how does the heat exchanger work, and should the pressure gauge rise when you have'nt got the heating side on but you turn the hot tap on. It does now but I never noticed it before. It moves up nearly Half a bar and then drops when you turn the...
Ok how's the pressure checked in the vessell. Is it a big job. I'm pretty capable of most things as long as it does'nt involve the gas.
Thanks again,
Mark.
How will I know if its got a hole in it. The heat exchanger was replaced about six months ago cos it was leaking on the floor. Could air be a factor. I can hear air around the pump when the heating is on.
I've recently taken off one of my rads to do a spot of decorating. When I re-connected it, I topped up the system to about 1 bar whilst cold. After turning on the boiler the bar increased to about 1.5 bar which is to be expected. I checked a couple of days later and the bar had gone up to over...