Hi alarm
Thanks some help, Alumni must have issue with people posting for help on a help forum, the AC fuse in the main panel is the problem not spur coming in. 2 amp glass fuse all zones have been bridged plus tamper and pa also. just need to know if to re-wire whole system again as...
Well I have not stripped a transformer to see whats broke inside or re-wired a circuit board yet but I am very competent in general electric’s, just don’t want to touch alarm panel board without asking as someone knows what it may have been,
low pressure hot water tap, well not water coming out hardly at all, gravity fed etc.. what can help me out here ?? The only thing i done was replace and old 2m long pipe from 22 to 15mm to go into the new taps that are 15mm, A bit dime i know but i have tiled the floor do i cant change back to...
Hi
This is what i have fixed so far:
new high output pump
new 3 way valve
Replaced all in and out valves on all rads
flushed system through both ways with mains pressure water
replaced hi & lo sensors on boiler
de scaled boiler heat exchanger
de-scaler in system
but after about an...
Hi
Working on it today, Is there any reset buttons anywhere as this mains gas is not getting into the chamber and there is no 240V going into the valve. It seems to be where the wiring section is, all of the live wires are 240 but when we get to the hi & lo thermostat switch things start...
Right i found the supply to the valve and there is a 24v going to the terminals in the valve when turned on, If it sounds like the valve gone then this will cost £80 wont it.
Hi all
I have an apollo 30/50b, early this week it tripped my house i changed the heating pump as i worked out this was the problem with it tripping but now i have changed it the pilot light is on and the pump runs when the timer is on but the main gas chamber does not ignite and i have not...