Matt887's latest activity

Yes, I've done Awakening and Mastery

How did you find it please? Also how long did it take to complete?

Hi has anyone done the heat geeks online training course? I'm thinking of doing it

How would you then clip the copper? Or don't and just clip plastic?

Have you seen before? Slit the plastic?

Could exit and go on to something like that?

I could run down the wall in copper but would be at risk of getting stolen

Thanks there is a waste pipe near by 40mm pushfit. But takes 2 sinks. If going into the waste it needs to be it's own leg no other...

Thank you it goes external at the moment but is high level and just stick out. Hate following rough plumbers . Best way of making this safe?

Is the over flow pipe similar to that of an open vented system header tank overflow pipe then?

Breather appears to be a safety vent/discharge pipe, so I would suspect operates via a PRV. Outlet from Tundish needs to be routed to...

Thanks there's no prv valve on it or temperature relief just a pipe coming from the top with a tundish

Haven't worked on that particular model ,but have worked on a couple of it's predecessors. The hot water distribution is gravity fed,so...

Was just trying to get my head around the breather pipe. This is like an open vent pipe?

Thanks yes this has a solenoid valve to open and close the flow of water on. Switched on via a high and low water pressure sensor.