Recent content by matty123

Good call - I will do that 8)

Hi. I want to board my loft for storage. The house is only 4 years old. I am only looking to board the central section of 6m x 2.4m. The joists in this section, 11 of them are at 600mm centres running 2.4 m in length. The insulation is in 2 layers both running between the joists and is...

Thanks for your comments. I will again check my connections in the ceiling rose to look for signs of stress. I certainly will not be plugging anything elese on that socket - I was even thinking I had better not use it for my drill when I finally get round to laying boards. :D Are you...

Hi. I needed to get power into the loft for a powered tv signal distributor. This uses a 12v plug in transformer. I therefore used about 3m of 2.5mm TandE ring main cable that I had, spurred off a ceiling rose, going to a standard twin socket. Is there any issue with using 2.5mm...

tried that - bit of air came out. Still not right though. Those rads that get hot are now getting fully to temp and the water temp is good to. I think I need to work out the order that the rads run so I can work out which specific on is causing the problem

Hi, i recently took off 2 rads in the same downsatairs room to respray. I have put them back on and now have no heat downstairs. upsatairs is luke warm as is the hot water. The boiler is on for a minute or two and then of for a couple then back on. Not sure what system details will...