Recent content by Mofofunk

Thanks for the reply on this. I think it might be an option to try a few different locations for mounting it and see if it inproves. Got it mounted on a large heat sink, under the TFT display, it's on a Triumph Street Triple RS 765, perfect location, shame about the vibes

Hi, I think this is the right section as it is regarding a camera (audio/visual). I have recently installed an Innovv C5 dash cam on motorbike. However, the foam washers they provide as part of the bracket assembly dont seem to offer enough 'anti-vibration' for my rather hard suspension setup...

Thanks for replies (and links) people - Think I'll do a bit more reading before i go any further with it; at least I know where to start with that :mrgreen:

Lmao! Well there you go, told you I'm not a sparky ..... Can someone give me a clue as to where to atart .....thank you

Hello, Can someone help me out? I know what I am carrying out will not meet correct UK standards for wiring etc, but its a quick fix, which will be removed eventually. I am looking to put a switched light and a switched plug into the garage....I have done a quick diagram (attached) of how...

This sounds like a good idea, do you possibly have a photo of how you have it set up? Just having a little trouble visualising it from the diagram ..... Thanks again

I was thinking of just putting some rawl plugs in there (brown ones; whichever size they are) rather than using 'expanding bolts' ....hadn't really considered that they might crack the concrete to be honest, glad you mentioned it though (y)

You're right, there are bolts holding the panels together, but I'd ruled out using these as the are 'the wrong way' for me to use them to attached brackets and there isn't really enough of them. The section I have taken a picture of was just to illustrate the type of material i am drilling...

Cheers guys for the quick response ..... The points which you have marked are excatly where I had in mind for drilling the holes.....that is where I actually put the one which killed my drill bit, I think drilling the centre of the panels would be very bad news so avoided that. Looking to fix a...

Hi, wonder if anyone can advise? I'm trying to drill some holes into my garage wall to put some brackets up for some shevles. Im using a new SDS drill (in the past I have always used a rotary hammer drill) and after drilling only one hole the drill bit is totally dead...see pic. Why? Do I...