Recent content by Monkeypowah

Reading other posts, it seems this is quite a common problem and the boiler is well rusty inside, a lot of the clips have snapped, I'm thinking of condeming it. Someone agree :)

Boiler is dripping condense down the back panel and filling up, cleaned corrugated pipe as best could and got a ton of grey crud out of it and the trap, but it still dripping, there is some coming out of the proper pipe. The problem is how do you get at the drip tray, it looks like it's a...

Ok just downloaded manual and seen that they al have a built in filling loop, the guy has built the mother of all tile diy boxes around bottom of boiler and is going to dimantle it himself, thats why can't isolate mains. But it has a filling loop under the unit that works, maybe the built in...

Got the old 24i with twin pipe heat exchanger, the system is filling even with filling loop removed and drops when you run the hot, all points to a leak between water and system, but can those twin pipe exhanger do that, seems unlikely a leak would find it's way into the other circuit, without...

For future reference, I dismantled the fan and the little clip that holds the bottom bearing in was loose, every now and then the armature was bouncing up and going into this weird mode while under power, take off the power and it span freely. It was one of those jobs where a few odd readings...

Thanks guys I'm am gas registered by the way, two things to mention ,i now find my meter is on the blink (works ok one everything except AC where it just bounces around, that's why I couldn't workout the fan voltage). Secondly, the fan suddenly did it when on normal mains after I ran it for a...

Just changed the fan for a proper part cos it was screeching and a few days later the boiler fails, this time the fan is running freely but when it recieves whatever power (can't work it out on my digital multimeter) from the board it just buzzes like it's forgotten to spin and just is...