I thought the amplifier has to be installed to the ariel input and then connect the rest of the TVs from feed from the amplifier. With your suggestion how would i connect the rest of the TVs.
During the new house extension a new fuse box was installed and I think the new two cables (light and socket) run directly from the fuse box to the new extension.
With above responses, I am confused. Are we sure that I can connect a new socket before the four new sockets supplied by a feed...
I have a loft TV aerial and planning to connect four TVs to it. I have been recommended to install a TV amplifier near the aerial with inlet of aerial connected to an amplifier and four outlets to the TV in different rooms. Amplifier needs a power supply. I recently had house extended and have...
Thanks again for prompt response.
I am a basic DIY person and am familiar with 230V. I just want to make sure that different make of programmer is not going to give problems to the operation of the Central Heating system. I am planing to go for Danfoss, Should I purchase any particular model...
Thanks for the advise. I have been away on holiday.
Are other programmers (other makes) easy to wire or connect? What about potterton 2 channel and is my existing past its life?
I have EP2000 central heating programmer. Recently when I put both hot water and central heating on (both switches down to bottom setting), the programmer makes a knocking noise (like solenoid rod moving in the coil). It does not make noise if i only switch on the water or central heating. Can...