Hi,
I am a Scout Leader and we are having some problems with a double strip light at the HQ. The light had started to flicker on start up but would eventually light up. This got worse and now it just flickers on and off. The problem is both tubes. We started by swapping starters but no luck...
Hi,
My Citroen Berlingo Multispace has frustratingly failed its MOT for the failure of the handbrake indicator light.
Now the light displays on the dash when you start the engine but does not light up when the handbrake is applied.
Under the handbrake itself is a simple make/break sprung...
The BG 330+ is not simply re-badged. It is a different from both the flexi and ultra. It is probably better described as a hybrid??
See no reason why a 330+ should prevent fitting an unvented cylinder.
I think this is a bargain, and actually a clever bit of kit with plenty of future potential
http://www.britishgas.co.uk/products-and-services/remote-heating-control.html
I suggest fitting a combisave [/url]http://combisave.com
These devices reduce the flow rate of hot water till it reached a sufficient temp.. This means the boiler runs for less time and less water is wasted. Double bonus if you are on a water meter.
Any pre-heat facility for hot water...
Check that it is not a problem with the signal. The RF will pass through walls but finds it difficult at acute angles. Also can struggle with foil backed plasterboard. Move the stat to see if this improves. Also check that the receiver is positioned correctly. The signal will struggle to...
Is the gas valve perhaps used on another boiler - Yes
Are the O-Rings listed in the parts for that boiler - Yes
Took me about 2 minutes to track them down. A further 2 minutes and I could confirm they were OK with the Manufacturer.
Job done and done safely.
Forgive me if this has already been asked (didn't come up on a search)
Is a Fein Multitool or similar any good for cutting ceramic floor tiles in situ. I know they are very good for removing grout but what about cutting tiles.
Thanks in advance
Simon
The drayron valves BG use are pretty unreliable, so could be.
As likely be a wiring fault from when it was changed.
Is it that the CH only comes on when the HW is calling and that is why it seems intermittent. Try having just Htg only from the clock??
I would go for the same way you drained it before. Just releasing the pressure is normally enough.
Not sure if this boiler has a drain point. Opening the PRV is not a good idea as it can lead to other problems.