Update, anyone following this thread
This was a faulty control panel.. The panel was not recognise the inboard expander. When going throb the first configuration setup. When asked do you want to default to wireless you should see
TKP>....
EXP>1.......
I didn't see the number one after EXP>no...
I took the commissioning jumper off
Entered zone setup
Toggled through from 1 to 9, but read 009 N1, E1, 1
When I push the reset button, small circle with arrow no change ar all to the display, it's exactly the same above
It was doing this when the commissioning jumper was fitted.
Ok so went into zone set up
Zone 009
Pressed x to enter edit mode
Set it as entry/exit
Keep pressing the tick button
Through wiring option
Get to the learn option. Still says "no ricochet"
Pressed the reset button
Nothing changed
Just tried and trying to load device to zone 009 still says not ricochet. Tried also learn device menu and that comes up with all devices learnt. Can't see how to add one
Hi, I have tried to add devices to zones 9-16 which I get part way through and then it asks for wiring configuration, when you get to wireless its says - no ricochet. So can't even add wireless devices manually. That's going through the add zones menu. I tried this with config jumper on and off...
Hi all
I have recently purchased the texecom premier elite kit 002 for my house. It has the 64W v5 control panel. I have watched a couple of youtube videos how to get the sensors registered onto the system bu my panel is not behaving the way the video shows.
I have the commissioning jumper...