Recent content by Oakey1967

Thank you for your comments. I changed all of the batteries one by one a few months back. Non of the PIR s flash when movement is detected so they are not indicating a low battery. There is a back up battery in the siren housing but an earlier post explained that the panel does not pick this up...

Thanks for the advice. Just to confirm I changed all of the batteries in the PIRs about 4 months ago so one of them may have run down but it would be a bit surprising. Any additional advice would be great. Thanks

Thanks for the advice. Just to confirm I changed all of the batteries in the PIRs about 4 months ago so one of them may have run down but it would be a bit surprising. Any additional advice would be great. Thanks

Thanks for your reply - you make a great suggestion and I will try this out this week. I hope this did not bring back too much of the frustration you had solving the problem. Thanks again

I have an on-going problem with my Response SA-P1 Wireless Alarm system. The low battery on control panel is flashing indicating a low battery in one of the PIR's. They all work ok in test mode but under normal operating conditions none of the lights in any of the PIRs flash indicating which one...

Sassie. Did you get this resolved? I have a similar problem but with a flashing loe battery on control panel indicating a low battery in one of the PIR's. they all work ok in test mode but under normal operating conditions non of the lights in any of the PIRs flas indicating which one has the...