Hi
I have built a brick surround for a multi fuel burner to mantle height. is it ok to complete this to ceiling height in studwork, assuming I will be using a twin wall flue?
Building regs state that the recess must be non combustable. do they mean simple the "fire place" or thw whole thing...
Hi
I have built a brick surround for a multi fuel burner to mantle height. is it ok to complete this to ceiling height in studwork, assuming I will be using a twin wall flue?
Building regs state that the recess must be non combustable. do they mean simple the "fire place" or thw whole thing...
My plans are asking for: Vapour control layer, 12mm marine WPB & 110mm polyfoam roofboard, foil faced and single ply membrane :?
It makes me wonder if my architect understands roof construction because I made it clear to him I wanted a GRP or Rubberbond roof and everyone I've spoken to in them...
Hi
With warm roof construction, how does the insulation glue/fix to the sub deck and then how does the top deck fix to the insulation prior to either GRP or EPDM.
Thanks
Hi
What advice or special tools would I require to remove the bottom two rows of eternit slate from my roof? This is to allow a flashing to go under and meet a new flat roof, prior to refitting them.
Any advice appreciated.
Thanks
It sound like the PCB is being fooled into thinking the doors meeting an obstruction which normally indicates a problem with the bottom safety edge.
This can be taken out of circuit via dip switches on the PCB and allows the door to operate "hold to run". Safety edges are renound to being...
Hi Chaps
Sure you've been asked this a few times already but here goes anyway.
New flat roof and unsure of how to cover it. I don't fancy felt, simply because it don't have a reputation of being permanent. It feels like a cheap and cheerful way to roof?. Is EPDM or GRP much better?. The one...