Recent content by paulcroad

hi can anyone help i replaced pcb board yesterday as the old one was faulty and also replaced c/h sensor as advised by an engineer and had water one changed a fews weeks ago, the problem is when i start the boiler up its runs for about 10 -15 secs and gets upto 40 temp and then cuts out then...

wen it fires up after bout 10 secs i hear a click from the pcb and then it cuts out

hi, guys thanks for your replies i've managed to get it started but it only fires up for bout 10 secs then goes off again

hi, yes followed the other board step by step, new board was set out slightly different tho, is the earth a yellow and green wire

hi, i've had various work done on my baxi 105e but it still wasn't working as it should be so the engineer said changing the pcb board was the last solution so i've done this as i didn't have the funds for him to do it but after doing this the above neons are now flashing so i'm guessing the...

thanks guys for your help i was just asking because i've got a friend of a friend who as been to see it and it's been leaking for some time and the pin is well an truly stuck and he as advised a new one he is charging £195 fitted so just wanted to no if i was gettting ripped off or not. paul

hi, i need a new divertor valve for my baxi 105e and just wondered if anyone knew the going rate to have one supplied and fitted by a qualifyed heating engineer

thanks, i've changed the ch diaphragm this morning but the ch pin is still not coming out but the ch does fire up when i press the switch if i don't press the switch the pump/ low pressure light flashes, so is that the pump knacked

it that the one where the other micro switch is

hi, thanks both for your replys, had pump replaced 12 months ago, changed hot water diaphragm bout 6 months, i cleaned return filter fews day ago before this started happening any clues on wot to do, yes be diy if i can bit short of cash at the mo. thanks

hi, hope someone can help when the central heating is switched on the pin is not coming out and connecting to the micro switch to fire it up does anybody no what this could be, also when the hot water is switched on it heats up to full temp and then cuts out and the central heating sensor...

hi, i have a baxi 105e boiler and i'm wanting to clean the heat exchanger out to see if it will cure the water running hot n cold ive taken this off but cant get in it to clean it any ideas. thanks paul

hi, just wondered if any1 can help i've got a baxi 105e boiler and when i turn the hot tap on the boilers not firing up to heat the water any ideas ? thanks paul

brill thanks dave i'll give it a try

hi dave plz cuds you give me a bit more info on where this is i would be very greatful