it says PRIMA B on it!
Like i say according to drawing the timer delay should cut pump out! Its costing me loads on gas and elec as boiler keeps firing up with the pump running all the time!
If it was up to temp the stat would be open. It should only close when tempature drops, thus energising pcb board and time delay and inturn energising boiler pump. once up to temp stat will open and pump should cut out within 4-6 mins.......
But why is stat constantly closed? On drawing it shows it being normally open. When temp drops stats closes putting a supply onto delay pcb and thus also bringing in motor for pump.
When stat opens when sufficient temp is reached delay timer should start and pump should cut off within 4-6...
the boiler is set on Max. Its the boiler pump that is running all the time, the one that that says primary return to heat generator. Its not the red ratiator pump. just turned power back on and now have buzzing noise from bottom pcb
Hi. I have tried turn stat between winter and summer but does not make any difference not does it effect Ohm reading when i put a multimeter on it and turn stat. Reading is allways o.1 Ohms.
Over 1 hour ago i disconnect stat from terminal 7 and just a minute ago boiler pump has cut out for...
CAN ANYONE HELP ME. I DONT KNOW WHAT MODEL BOILERMATE I HAVE BUT HOUSE WAS BUILD IN 1993/94. BOILER PUMP (BLUE LOWER ONE) IS RUNNING ALL THE TIME COSTING ME IN ELEC AND GAS. THE STAT IS ALLWAYS CLOSED WHEN I TESTED IT SO I THOUGHT THIS WAS THE PROBLEM BUT WHEN I TOOK THIS OUT OF THE CIRCUIT...