Hi, can anybody advise on this?
Do these attachments work by regulating the amount of cold water flowing in? Reason I ask is that I have mains pressure on hot and cold and a combi boiler. Currently use a manual bath shower mixer tap arrangement and regulate the temperature by turning the hot...
Hugh,
Many thanks. The item I wish to replace is also a Fordham. The one you mention is a bit wide and also seems to only allow a right hand cold water feed so no good (space limitation). Beginning to think that I will make the search easier if I go for a 6L model. Maybe firs try...
So, with regard to the regs, I guess I will may have to take my old 9L cistern to the shop with me when buying a replacement. Is this another piece of EU nonsense? Can't even take a d**p with the EU involved, now, if so.
Hi, don't know if anybody can help with this. Had a look around the Web without too much success.
Am looking for a plastic or ceramic replacement exposed cistern that can flush up to 9 Litres. Complication is that I want one which has the flush button on the top of the cistern rather than a...
Hi, have a flexible, braided tap connector on the hot supply to a kitchen mixer running from a combi, so at mains pressure. Have noticed that there is a little bit of corrosion on a part of the steel braid and a couple of strands are standing proud. (Happened because the was water ingress under...
Hi. Have a mixer tap unit fitted onto a steel bath. Plumber did not manage to fit it 'square', ie, parallel to the wall, so looks awful. Also suspect that the rubber gasket has been damaged owing to the use of 'Dettox' to keep on top of black mould. Intend to refit the unit probably using flexi...
Thinking of installing an IKEA wall hung bathroom basin.
http://www.ikea.com/gb/en/catalog/products/20223716/
This weighs 16kg and is held onto the wall using two bolts! Concerned about obtaining a sound fixing without overtightening the bolts and damaging the basin. Thinking of putting a...
The gasket beneath the bath taps block has been rotting, quite possibly owing to Dettox fungus remover having been used. Wish to replace this gasket. Would it be possible/effective to remove the taps block and the gasket and then smear silicone bath sealant on the underside of the block such...
Hi. If the CH is running and I turn on a hot top it initially, for a few seconds, runs much botter than it would do if the CH was off. Know this as have put my hand underneath and also a thermometer. (Could not read the actual temp.) Then settles down to the correct temperature. Did not realise...
Want to use flexible tap connectors (maybe John Guest). Note that these can cope with up to a water temp of around 65 degs C. With the combi boiler I have, if the CH is running, the water from a hot tap may initially run much hotter than the temp set for hot water on the boiler (Worcester Bosch)...