Recent content by philip73

Think what Goldberg was trying to say is have you brought taps that are designed for high pressure rather than gravity fed.If the flow rate was fine before then I would say you have brought incorrectly. You could raise the level of the tank or fit a pump or you could buy the right taps!

Ideally I would run a seperate waste and buy an all in one waste/trap with 75mm seal.You should be able to fit in the depth if your careful with waste positioning or if it is sitting up on timbers/legs.

Thanks very much!

Guy's, Any remaining air is going to work it's way out of this system anyhow through the automatic air vent in the combi - but I think its good practice personally, but obviously more so with open vented systems to help stop corrosion of the rads. Saves re-pressurising again the next day if...

You can, but you might want to make sure that you have water right up to the point of the cap when re-filling to avoid trapped air and the issues associated.

I am building an extension and it runs the exact length of the existing house.As it is built from block and is to be rendered on the outside, should I set the the two end walls back from the existing brick so that the render finishes flush or should I run the block in line with the existing...