Recent content by prbuk

I think this is where the massive thank you comes in..............I had set program 1 to be as I wanted it, e.g. zone 1 used, 2-7 unused. What I hadnt done is set P2 and P3 to the same............ Having just done that it does what I was expecting, i.e. a 0 until i opened the door when it...

photos uploaded Red and black across reed. blue and yellow joined Showing all factory shorts Shorted zone 1 LCD panel (doesnt show much without rear of panel I guess) What it was like before I went into debug mode

Do these work? I'll check and if not revise how I load them...... Wiring at the door switch (not currently used testing via the shorted circuit). Red and black across the reed switch, blue and yellow joined at the junction. Resistance of red and black when closed is 1.8ohms, and when door...

Hi Alarm, I know where you are coming from. Followed instructions as advised to the letter and no change. So acknowledging I'm here because i'm doing something wrong, the question remains, what I dont understand is what am i doing wrong given I am following the instructions explicitly...

Sorry if I come across in any way that could be considered as being unfriendly. I'm feeling massively frustrated at needing to get this done asap as the missus now doesnt like being at home at night without an alarm, I've got kids running round screaming, I clearly need to take a step back and...

Oh my god, just received new panel and I get EXACTLY the same problem, so I'm wondering if i am following the correct process. The manual is a little ambiguous for first power up....... Should the mains be connected (does it make any difference?)? The diagram for first power up doesnt...

Hi, The resistance of a circuit (black and red connected to opposing ends of the reed) at the alarm panel when closed (obviously) is about 3ohms when measured with my calibrated fluke 1653, when I open the door, the contacts open and resistance is infinity. The blue and yellow are wired to the...

Hi, Thanks for all replies so far. Sadly no progress as yet. In answer to the Q about the cover being open, technically yes it is, however, my finger is pushed firmly on the spring and the tamper part of the walk test remains at 0 (zero) so this bit works. I've done another reset having...

Sorry, X = No. All walk tests were starting of at 1 instead of zero, so after some research, the way of eliminating any wiring issues is to short out the circuit, thus on walk test the test should give a 0 to start with, but of course it will stay at zero as it cant be opened. It should go...