Recent content by pukka

yes had one in our door, cannot remeber how it works. but if i remember it takes a 9v battery.

At work we use EXCEL http://www.excel-networking.com/home/ have used it for over 17 years now.

don't know the blue pipe size, also if the parts bellow are correct. my pipe was 20mm so completely different parts http://www.screwfix.com/p/floplast-mdpe-plastic-wall-plate-elbow-25mm-x/77864 with http://www.screwfix.com/p/15mm-x-outside-tap-with-double-check-valve/37241

if you have a Costco near by, they do a pack of 3 stabile levels for about £35 ish

try tapping the chuck with a hammer, and if that does not work remove the bolt inside remove the chuck and install a new one. (swapped mine our for a dewalt one from screwfix) did try and free the old one with some big blows with the hammer but was still stick solid.

I have had a few battery's recelled, used http://www.multicell.co.uk/ on one set they upgrade the battery's too Paul

I would guess put it in engineer mode.

attach http://www.screwfix.com/p/straight-door-bolt-polished-chrome-38mm/31382 under the draw on each side and lock them in to the legs " desk uprights" Paul

look at it the other way, if the plug with the pins is already attached to the appliance then the statement is correct.

I have a snapped fob, rough up the ring part with sand paper, then covered the ring part in araldite. left it 24 hours, drilled a new hole in it. it been like it for 3 years now. Paul

I use http://www.wera-tools.co.uk/catalog_uk.html?L=1&file=/en-UK/root_category_screwdrivers_series_kraftform_micro.html they are very nice, just not the cheapest but the quality is great. Paul

get the correct kit and watch a few youtube videos. I have http://www.ebay.co.uk/itm/14-Ettore-Brass-Squeegee-14-Washer-Set-XL-Microfibre-/120433070476?ssPageName=ADME:L:OC:GB:1123 and use ecover...

I don't think its any cheaper. http://www.vesternet.com/z-wave-fibaro-home-center-2-system £497 http://www.interaktivahem.se/p/styrenheter/fibaro-home-center-2.html £483 according to xe.com today

they can also make silicone moulds from your object, then cast it in the resin, I am not sure if they could make a silicone mould from plasticene tho. Paul

how about some resin casting. http://blackdragoncastings.co.uk Paul