Recent content by pwilki

No. Its just a metal arm with a 90degree bend at the float end, and the float is fixed to this via a retaining screw. The other end is secured to the valve body via a split pin, and the metal arm butts up against a plastic bung protruding from the inside of the valve body. The noise is loudest...

There were no other 'inserts' in the pack... How can i find alternative inserts that are the correct type...?

Any other ideas???

Thanks for your quick reply! I bought the kit from B&Q, and it says "cold water header tank kit" on the front of it. Nothing is mentioned about pressure reccomendations - but i take it all header tanks are mains fed??

How can i stop the whistling noise after every toilet flush? Yesterday I noticed the overflow was dripping - after investigation, i found the ball valve to be covered in scale and it could not shut the valve off fully. So i replaced the ball valve (allbeit with a slightly different style -...