I have looked everywhere to find out the type and thickness of the rope seal needed for my Danesmoor 15/19 (circa 1993). I think it is around 12mm but would welcome any advice on size, type and adhesive I should buy along with any fitting advice.
Thanks for the advcice, looks like the HP union is fine.
The leak dissapeared for a few days then suddenly started again, enough to wet the base of the boiler. Can this sort of intermittant leak be from the solenoid (can't remove the coil as the retaining nut is stuck) and what about the pump...
The outlet connection (pressure to the nozzle) on my Danfoss BFP 41 L3 wont stop weeping. I have removed the outlet pipe and cleaned inside the connection both in the pump and on the connecting pipe. I don't want to keep tightening it more and more.
Any advice welcome.
Thanks for the replies.
I have just tried levering it to try and get it to go, but no luck. Have sprayed small amount of WD on and will leave a few hours.
Does anybody know where I can get a cheap pressure guage and fittings just in case I have to fit a new pump (have ordered a pump ready...